
MAH-ZH 16.5/120
PITFORCE | Axle and Transmission Jack Hanging telescopic jack with 16500 kg load capacity
VP 454225
Description |
Description:
- The telescopic pit jack is track-guided at the upper edge of the pit for easy movement, even under load
- Universal jack for lifting high loads and flexible component removal thanks to large travel
- Very flat double telescopic lift for the removal of large components from the vehicle
- Optimal foot control for rapid and power stroke for better control of the load and the pit jack
- Pneumatic quick control facilitates fast post lift to the load uptake point
- Flexible pit jack remote control for installation works and access from both sides of the pit (optional)
- Discharge spindle with dead man's control enables particularly delicate/precise and secure discharge of the pit lift
- Cylinder retraction is supported through compressed air. This means that vehicles can drive off the pit without obstruction.
- Delivery only with filled-in dimension sheet to adjust the pit jack to the existing pit
- Customised carriage ensures a precise fit for the existing working pit
- All rollers feature needle bearings in transverse and longitudinal direction to facilitate easy movement
- Compressed air maintenance unit with inspection opening for monitoring oil and water levels to maximise the service life of the pit jack
- Inspection window for controlling oil quality and water content in the pit jack
- Protective covers for all control elements, piping, compressed air motors and moveable elements
- Tool storage in the handle
- Piston rods are hard chromium plated, and to prevent rust in the jack, the inside is flushed with hydraulic oil with every complete lift.
- A high-quality powder coating offers protection against aggressive liquids and adds to the high-quality aesthetic of the products
Standard Delivery:
- Pit jack with hanging carriage
- Rapid control and compressed air motor
- Standard supports 120 x 120 mm
- Inner flange rollers
- Operating manual and test log
- EC conformity certificate CE
- Type tested
Documents |
Technical data |
Load capacity CE | 16500 kg |
Full travel | 1200 mm |
Track width inner dimensions | 750 mm - 1200 mm |
Ram diameter | 70 mm / 115 mm |
Diameter of supports inside/outside | 45 mm / 70 mm |
Motor max. | 350 l/min 10 bar |
Operating pressure | 254 bar |
Weight | 400 kg |
Images |
Request for quotation - MAH-ZH 16.5/120